1070 Nine North Dr Alpharetta GA, 30004 (770) 667-0667
 
PMC Home Products Documentation Gallery Contact Information
   
-Products-
Marine Dispensers
 
Aviation Dispensers
 
Fleet Dispensers
 
Equipment
 
Custom Systems

Click here for larger image

Meter Stand Fleet Dispenser
- 35 & 60 GPM Configurations
- Designed for the commercial environment
- Liquid Controls 1-1/2" PD meter
- Integral nozzle boot, hose hanger and ON/OFF switch
- Internal solenoid valve
- Optional satellite feed
- Optional interlock / forced reset
- Optional pulse output
- Optional printer
- Optional stainless steel construction
 
Data Sheet
 


The MSH series meter stands are designed to provide low cost, high speed fueling. Two configurations are offered at nominal flow rates of 35 GPM and 60 GPM. Actual flow rates may vary depending upon pump size and installation conditions. The meter stand's 8 ½" square column is fabricated from 12 gauge steel while the 14" square base is 7 gauge steel. Meter stands are powder coated in OSHA safety green as standard.

The meter fitted to each model is a rotary, positive displacement, high accuracy Liquid Controls model M5 with nominal perating range of 5 to 60 GPM. The standard assembly is fitted with a register that has a 5 digit resettable counter and a 7 digit non-resettable totalizer reading in 10th gallons. Other increments of measurement are available include liters and whole gallons. Conventional accessories including a ticket printer and 10:1 or 100:1 pulser are available as options. Inlet filter assemblies and counterweight hose hanging devices are available as well.

The MSH series meter stands are each fitted with a nozzle boot designed to accommodate either a 1" high speed nozzle (7H style) or a 1½” high speed nozzle (1290 style). The MSH-32 & MSH-34 series meter stands have 1” internal piping including a 1” solenoid and a 1” outlet hose connection. The MSH-34 series adds a fuel block on the discharge side of the meter for use in piping to a satellite hose stand. The MSH-62 & MSH-64 series meter stands have 1½” internal piping including a 1½” solenoid and 1½” outlet hose connection. The MSH-64 series adds a fuel block on the discharge side of the meter for use in piping to a satellite hose stand. Both the 1” and 1½” solenoid valves are rated for continuous service and come standard with Buna ’N’ trim for diesel service. Gasoline, diesels with certain additives , and other specialty fuels require the optional Viton trimmed valve. The internal 20 amp DPDT on / off switch controls the 1½” internal solenoid valve and can be used to control an isolation valve, pump motor starter, or other process control device.

 
   
PMC Home Products Documentation Gallery Contact Information